The graceful contours of the Fretz RH Holder make it possible to reach into bracelets and other hollow shapes that cannot be struck with a hammer and conventional chasing tools. Simply install one of the 7 Insert Stakes into one end of the Holder and strike the other end with a hammer while grasping the knob on the side of the tool. The article being worked is supported in chaser’s pitch.

This makes it possible to avoid the kinking that happens after a bracelet is chased flat and then curved into a round or oval shape. The curved Insert ends form delicate flutes or raised areas from the inside. The 7 Inserts used with this Holder are the same as the ones provided with the Fretz Maker® Insert Hammer (see related products below). The Holder may be purchased without the Inserts. The Holder measures 4” long by 3” high.