Durston's new 11 Piece Ring Shank Bender tool incorporates eleven sets of dies: nine rounds, one square and one rhombus. The dies are manufactured from hardened and polished tool steel, precision-made for optimal performance. Each round die has a radiused edge to minimize any damage to the material being worked. A unique gearing system provides effortless bending. The Durston Ring Shank Bender will bend material up to 2mm thick. Also included in the set are Delrin dies for all 11 pieces. The set is compact with the lower half housing the main body. The main body can be used in the tray holder itself. Just swing the top out the way, or you can remove the bender and bolt it to a table. Alternatively, screw on the vise locater and hold the bender in a vise. Measures 11" long x 7-1/2" wide x 6-1/2" high and weighs 13 lbs. Made in England.

• 9 Round Posts (8, 10, 12, 14, 16, 18, 20, 22 & 24 mm)
• 1 Square Post
• 1 Rhombus Post

NOTE: For use with dead soft metal, 2 mm thick or less. Metal must be annealed before bending.